DARDwyer Augmented Reality
checking link…

Spatial operations · plant & warehouse

Find anything.
Through the wall.

Tag equipment, inventory, safety gear, and shutoffs where they stand. Then walk straight to any of them — the nearest eyewash, a picked part, a breaker two rooms away — guided by an arrow with live distance, straight through walls.

Put the headset on and open this page in Browser to enter AR.

Locate through walls

Pick anything, or ask for the nearest — an arrow guides you to it with live distance. Breakers, drives, eyewash, a pallet in the next aisle.

Inventory & bins

Tag racks, bins, and staging lanes with a live count. Set or adjust quantities by voice as you pick and put away.

Guided routes

Build a pick list or an inspection round, then get walked stop to stop — the arrow advances as you reach each one.

Safety & shutoffs

Mark eyewash, extinguishers, E-stops, and utility shutoffs. In an incident, find the closest one in seconds.

🎙

Voice capture

Point, pull both triggers, speak. Faults, readings, and notes are logged, dated, and pinned to the exact spot.

Measure & PM

Measure clearances point-to-point in place, and set service intervals so overdue assets flag themselves.

Site overview

0Tags placed
0Inventory on hand
0Open faults
0PM due

Nothing tagged yet. Enter AR, set two reference points, then point at anything and pull both triggers.

System check

Passthrough ARchecking
Assistant serverchecking
Microphonenot tested
Voice playbacknot tested

In the headset

  1. Set two reference points. On entry, point at two fixed spots you'll recognise next time and pull both triggers on each. Everything anchors to those — nothing to fill up on the headset.
  2. Tag anything. Point, pull both triggers, say its name. Set its kind — asset, inventory, safety, shutoff, inspection, note — from the Assets panel. Inventory gets a live count.
  3. Find the nearest. On the Ops panel, pick a target (eyewash, extinguisher, E-stop, a fault…) and hit Go — the arrow takes you to the closest one.
  4. Run a route. Add stops with +Route, hit Start, and get walked stop to stop for picking or inspection rounds.
  5. Measure. Ops → Measure, point at two spots, get the distance in place.
  6. Talk to a tag. Look at it, hold grip: "add 6 to the count", "this is fixed", "what did I do to this last". A / B add a voice memo to whatever you point at.

Either controller works for everything. Only one controller? A single trigger acts as "both". Meta button leaves AR. To walk the whole site, turn Boundary off: headset Settings → System → Developer → Boundary.